2007-2017 Toyota FJ Cruiser - MACH Force-Xp 2-1/2 IN Single Rear Exit Stainless Steel Cat Back Exhaust Systems

Test Results:
In testing, the cat-back exhaust system resulted in gains up to +9 horsepower and +19 lbs. x ft. of torque, as measured on our in-house dyno (tested on 2008 Toyota FJ Cruiser V6-4.0L)

aFe power introduces an all new Rebel Series dual middle-side exit exhaust system for the 2007-2017 Toyota FJ Cruiser with V6-4.0L engine. This cat-back exhaust is constructed of 2-1/2" mandrel-bent 409 stainless steel and comes complete with free-flowing muffler, tubing, OE style bayonet hangers, band clamps and all hardware necessary for a hassle-free installation. The smooth curves and increased diameter of this exhaust system helps remove restriction and keeps exhaust gas flowing smoothly for increased horsepower and torque. The system is finished off with a high luster polished 304 stainless steel, rolled slash cut tip for an aggressive style.

Installation is a Snap:
This MACH Force-Xp use all factory mounting locations providing stability and a hassle-free installation.

Leak-Free Seal:
High quality OE style flange and band clamps are used for a complete 360-degree sealing surface eliminating leak paths.

Aggressive Sound:
A straight through designed, free-flowing stainless steel muffler is used to absorb high pitch tones producing a powerful sound and unleashing all available horsepower and torque out of your rig.

Perfect Fit:
OE style bayonet hangers are used to maintain a stable pipe location during high vibration and high heat conditions. The Bayonet tip holds the hanger bushing in place for an OE style fit that does not change with time.

Flow and Performance:
MACH Force-Xp exhaust systems are constructed of 2-1/2" mandrel bent stainless steel tubing for maximum flow. Smooth transition bends allow for low turbulence, increasing horsepower, torque and improving throttle response.

Polished Tip:
Finishing off this system is a 4-1/2" diameter, polished, stainless steel tip. The tip comes with a laser-cut aFe Power badge riveted on for an aggressive style.

Note:
Will fit TRD Edition models.

Emissions Disclaimer:
This product does not require a CARB EO#

All aFe exhaust systems are engineered and manufactured in our Corona, California facility.